View Single Post
Old January 21, 2013, 02:10 PM   #5
Magnum Wheel Man
Senior Member
 
Join Date: July 26, 2006
Location: Southern Minnesota
Posts: 8,535
Thanks for the reply's... We did watch the DVD, when I came over ( at least most of it ) & pictured in the DVD, the tubes were in the the powder hopper, not in the tube ( at least now ??? )

still curious on the primer set up... the plastic wheel follows the rod correctly, just that the shuttle doesn't come out after the wheel pulls away from the rod... seems like the shuttle is tight in the housing ( casting line, burr, or something ??? ) by loosening the nut so the riser could rock a little, it helped, but still seemed to bind up on occasion...

& I did tell him these are highly sensitive to dust & dirt, & he's going to have alot of problems if he leaves it where he's doing woodwork...
__________________
In life you either make dust or eat dust...
Magnum Wheel Man is offline  
 
Page generated in 0.04321 seconds with 7 queries