View Single Post
Old January 21, 2013, 12:09 AM   #1
tonymazz
Junior Member
 
Join Date: August 17, 2012
Posts: 13
Cleaning a Henry Big Boy 44 mag

Ok so reading the manual it says doing some basic cleaning, patches down the barrel is ok....no dis-assembly required...

For those of you that own a Henry....seriously...do you take the stock off pull the brass cover and start tapping out parts to clean.... that's like 30 parts...or do you simply run a bore snake through or rod / patches, general clean up of the fouling, q-tips etc and keep the thing assembled...

I have seen on the Henry sight a couple of cleaning video's but I am not looking at taken this thing down each time....strip screws, scratch etc etc.....


Thank you for your guidance.....
tonymazz is offline  
 
Page generated in 0.04851 seconds with 7 queries