View Single Post
Old January 20, 2013, 08:11 PM   #4
Marquezj16
Senior Member
 
Join Date: April 3, 2011
Posts: 2,088
I am assuming that you have removed the gas block from the barrel and the gas tube came along with it. If that's the case, then spray a little penetrating lube where the gas tube goes into the gas block. Then get a good grip on the gas tube and slowly tap the block off. Should not take much force. I use a little brass hammer but you could probably use a screwdriver handle.
Marquezj16 is offline  
 
Page generated in 0.04220 seconds with 7 queries