View Single Post
Old January 20, 2013, 02:10 PM   #1
kingemandigger
Member
 
Join Date: January 2, 2013
Posts: 16
Lee resizing die question

I recently set up my lee challenger press and wanted to test the lee decapping and resizing die on some new brass before I primed it. I have new starline 45 colt cases and lee resizing lube. I tightened the die to where it was just touching the shellholder. after sending one through the die, I noticed that it sized the case a little small. there is a slight bulge at the base and to test the size, I tried to put the lee case trimming measuring rod through the case, It didn't fit. Now I know that new cases should come at right width to begin with. Also, I will not be able to trim cases after depriming them Does anyone have any suggestions, is this normal, etc. I certainly dont like anythin less than precision for reloading
kingemandigger is offline  
 
Page generated in 0.04978 seconds with 7 queries