View Single Post
Old January 20, 2013, 12:42 PM   #2
Ifishsum
Senior Member
 
Join Date: September 15, 2005
Location: Oregon
Posts: 710
If I'm not loading again within I week I would store powder back in the original container rather than in the load-all. It is a bit of a pain to be sure; I actually mounted mine to a piece of plywood and use clamps to hold it to the bench. Makes it easier to dump unused powder back - otherwise you have to scoop and/or cycle the charging lever until the hoppers are empty. Changing a bushing on a full hopper is a real mess - so before starting a new load, I load the hopper only 1/4-1/3 full with powder and verify the throws on my scale before adding shot and filling up the powder. Then I record the recipe including the bushing number so it's easier the next time.
Ifishsum is offline  
 
Page generated in 0.05688 seconds with 7 queries