View Single Post
Old January 18, 2013, 03:04 PM   #21
musher
Senior Member
 
Join Date: April 23, 2005
Posts: 426
Yeah, I was trying to imagine how to test that. Seems like you could at least measure whether the face of the forcing cone is square. It should protrude the same distance from the frame on each side if the inner face of the frame is flat.

If the forcing cone face is square to the barrel, wouldn't that imply the cylinder must be the part out of line?
musher is offline  
 
Page generated in 0.04770 seconds with 7 queries