View Single Post
Old January 18, 2013, 12:19 PM   #11
whiplash
Senior Member
 
Join Date: January 18, 2007
Location: Idaho
Posts: 331
Thanks for the replies. I did use RickB's tip and had interference with the firing pin travel, However, I was doing this with the barrel pointed down on the table. Once I put the gun parallel to the ground it had clear travel. I did remember that the last disassembly I noticed the firing pin plunger spring cocked a little bit, possibly from my last install. And yes I wouldn't expect the firing pin stop to have dimples and the opposite bumps. It's like someone used a flat ended punch for one side and the other side has what would be the opposite with round bumps. When I get a chance I will take a pic that would help explain. Unless someone with a Taurus beats me to it.
whiplash is offline  
 
Page generated in 0.04326 seconds with 7 queries