View Single Post
Old January 18, 2013, 10:09 AM   #11
rodfac
Senior Member
 
Join Date: January 22, 2005
Location: Kentucky
Posts: 1,636
Serenity....I've used and appreciate both the Wilson crank model and Lee's simple cutter, shaft, and case holder model....both work well but the Lee is dirt cheap, works well with a drill press if you need vast numbers trimmed in a hurry and is accurate. On a budget, I'd go with the Lee...and I use both models on almost a daily basis. HTH's Rod
__________________
Our Flag is unfurled by the dying breath of our patriots in uniform. Cherish and honor it, defend what it stands for or get the hell out. Our Freedoms are not free, they've been paid for many times over.
USAF Forward Air Controller, 5th Spl Forces,
An Loc, lll Corps, RVN, 69-70, Vietnam Vet '69-'73
rodfac is offline  
 
Page generated in 0.04656 seconds with 7 queries