View Single Post
Old January 16, 2013, 06:44 PM   #4
OkieCruffler
Senior Member
 
Join Date: July 9, 2001
Location: Denison Texas on the banks of Texhoma
Posts: 1,484
I never had the problem with mine but if you want to really cure the problem have the chamber cut for rimmed brass. You can use 303 (and 30-40 I think) brass to form and then you're good to go. I shot a few hundred thru mine without a problem but I never used factory loads, I think that is where alot of the problem comes from.
__________________
John A. Monroe, Never Forgive, Never Forget, Blood Pays Blood
OkieCruffler is offline  
 
Page generated in 0.05042 seconds with 7 queries