View Single Post
Old January 16, 2013, 12:18 AM   #3
Dannyboy303
Senior Member
 
Join Date: February 27, 2007
Location: QLD, Australia
Posts: 116
Quote:
reloader28 You could also measure the chamber length and trim the cases so that they are only .003-.004 under that length.
Everything I've checked, that means the case is going to be longer than factory specs (over max), so it has to be for THAT gun.

You dont have to trim to min, but you need to trim so that they are all the SAME length.
Wouldnt i have to do a chamber casting for that or is there an easier way?
Dannyboy303 is offline  
 
Page generated in 0.04085 seconds with 7 queries