View Single Post
Old January 15, 2013, 09:35 PM   #11
crawdad185
Member
 
Join Date: October 29, 2008
Location: GA
Posts: 32
Ok, just got through checking a few things. Turned the release screw out one turn, didn't seem to make any difference than sitting flush. However, in the process of checking, I think I may have stumbled onto something. The release button is, in fact, releasing the cylinder fine as best I can tell. The problem seems to be in swinging the cylinder out. It seems to be rubbing kinda hard on the forcing cone of the barrell. The front of the cylinder is shiney where it has been rubbing and I can see some wear on the cone itself. I'm thinking maybe it sits too close to the forcing cone, or when I'm opening it, I'm forcing the cylinder into the forcing cone. The cylinder is not touching the forcing cone when it is closed and no pressure put on it. I can see a slight gap when I hold it up to a bright light. However, I can push the cylinder forward slightly until it makes contact with it. I don't know if any of this means anything, but would like to hear what y'all have to say about it. Thanks
crawdad185 is offline  
 
Page generated in 0.04374 seconds with 7 queries