View Single Post
Old January 14, 2013, 06:34 PM   #12
m&p45acp10+1
Senior Member
 
Join Date: May 3, 2009
Location: Central Texas
Posts: 3,307
I inspect cases. If something does not seem right then I use a pair of pliers to bend the brass so that it is not able to be used again. I then put it into my recycle bucket.

Step one look for obvious signs of bad brass. Splits, separation rings, badly bloated cases, ect. ect.

Step 2 For bottle necked cases, and .30 Carbine. I paper clip test for seperation by using a bent paper clip inside. If a case has a cut in it the paper clip will catch. I crush those, and into the recycle bucket they go.

Step 3 Size. Then measure.

Step 4 Trim if needed.

Step 5 Prime. If the primers feel like they are seating too easy then I remove the primer, and scrap the case.
__________________
No matter how many times you do it and nothing happens it only takes something going wrong one time to kill you.
m&p45acp10+1 is offline  
 
Page generated in 0.04439 seconds with 7 queries