View Single Post
Old January 13, 2013, 10:00 PM   #13
Wyosmith
Senior Member
 
Join Date: December 29, 2010
Location: Shoshoni Wyoming
Posts: 1,022
I can tell you a quick easy and fairly cheap way to go Crosswire.
Cut off the shank. Rethread to the correct specs and rechamber. Cut for the extractor.
Now, shank the muzzle at 5/8X24 and add a muzzle break. Pin it on and weld over the pin holes (makes it a permanent part of the barrel according to ATF.)

Done.
Wyosmith is offline  
 
Page generated in 0.03903 seconds with 7 queries