View Single Post
Old January 12, 2013, 02:14 PM   #2
WVsig
Senior Member
 
Join Date: June 30, 2010
Location: KY
Posts: 3,453
Ok did you ever try to decock the pistol? Insert mag load the chamber and then decock the pistol to DA mode?

If you did would the pistol's hammer stay back after firing from the DA mode?

It sounds like the hammer was not resetting.... was the trigger fully reset?

From what you are describing it sounds like there is a issue with the hammer and the sear engagement. The hammer is not resetting because it is slipping off the sear. Could be as simple as the hammer return spring is not properly set.

Best thing to do is call Sig on Monday.
__________________
-Fast is fine, but accurate is final. The trick is learning to take your time when you're in a hurry." -Wyatt Earp
-Its a tool box... I don't care you put the tools in for the job that's all... -Sam from Ronin
-It is the mark of an educated mind to be able to entertain a thought without accepting it. -Aristotle
-Without deviation from the norm, progress is not possible.-Frank Zappa

Last edited by WVsig; January 12, 2013 at 02:22 PM.
WVsig is offline  
 
Page generated in 0.04872 seconds with 7 queries