View Single Post
Old January 12, 2013, 05:46 AM   #12
Senior Member
Join Date: July 28, 2007
Location: Central Ohio
Posts: 10,199
The trouble I had was alliants print out only said 6 grains didn't say min or max. So I was unsure.
I urge you to look again -- perhaps not in that immediate column with the actual data, but somewhere on each page. Top or bottom. Alliant will specifically state that the listed loads are maximum loads and should be approached with caution, typically reduced by 10% to start.
Attention Brass rats and other reloaders: I really need .327 Federal Magnum brass, no lot size too small. Tell me what caliber you need and I'll see what I have to swap. PM me and we'll discuss.
Sevens is offline  
Page generated in 0.06628 seconds with 7 queries