View Single Post
Old January 11, 2013, 11:37 PM   #10
anthonycd1
Member
 
Join Date: January 9, 2013
Location: falmouth maine
Posts: 22
Thank you all very much. This is a lot of help. The trouble I had was alliants print out only said 6 grains didn't say min or max. So I was unsure. I have Several manuals but plated bullet .40 cal data seams to be kind hard to come by. What's a good book for load data to buy? I have have a book but there isn't much on .40 in it. I have unique powder should I swap out the bullseye since I am pulling the bullets any way? How much unique? I say hard crimp but I am using lee dies came in a set of four. I think it is a taper crimp the directions said turn out half turn for soft crimp and full for harder. Think I will reflare and put soft crimp on. Thanks again all I am very impressed with this forum and its members.
anthonycd1 is offline  
 
Page generated in 0.04481 seconds with 7 queries