View Single Post
Old January 11, 2013, 07:41 PM   #10
Gunplummer
Senior Member
 
Join Date: March 11, 2010
Location: South East Pa.
Posts: 1,505
I agree with Scorch, orrrrr it is only a 9MM. There may be enough room to turn down the shank, thread it to a smaller diameter thread, and them make a sleeve that threads onto the barrel with the correct thread on the OD of the sleeve. If you want the original stampings that is an option. It has been done before.
Gunplummer is offline  
 
Page generated in 0.04571 seconds with 7 queries