Thread: Crimping Cases
View Single Post
Old January 10, 2013, 08:03 PM   #9
hardworker
Senior Member
 
Join Date: August 4, 2010
Posts: 820
Well, laziness set in and I have yet to get to this part of my operation. So as I understand it, the seat die also crimps if it is adjusted correctly. This is a roll crimp correct?

Is the best way to do this simply to seat in one step and adjust the die afterwards to crimp them all?

How do I adjust the die to do that? Screw it all the way out?

BTW I'm using jacketed bullets at the moment but I've read that lead can be done this way too without and problems.
hardworker is offline  
 
Page generated in 0.06126 seconds with 7 queries