The Firing Line Forums - View Single Post

spacecoast · January 10, 2013, 07:31 AM

Thanks Mike, I bought the holster before we had our deal going on the bullets or I might have taken you up on that. I have seen your work and know you make a nice product. It's not fancy for sure (definitely low end), and I probably wouldn't use it on a nickel or blued gun (that rivet from the big snap rubs the cylinder) but I have quite a few stainless revolvers and it's a serviceable holster for those for just riding around the farm.

I misspoke when I mentioned the holster covering the trigger guard on the K-frames, it rides as shown above for those too. Not sure where I got that.

January 10, 2013, 07:31 AM	#4
spacecoast Senior Member Join Date: October 14, 2009 Location: Sunshine and Keystone States Posts: 3,391	Thanks Mike, I bought the holster before we had our deal going on the bullets or I might have taken you up on that. I have seen your work and know you make a nice product. It's not fancy for sure (definitely low end), and I probably wouldn't use it on a nickel or blued gun (that rivet from the big snap rubs the cylinder) but I have quite a few stainless revolvers and it's a serviceable holster for those for just riding around the farm. I misspoke when I mentioned the holster covering the trigger guard on the K-frames, it rides as shown above for those too. Not sure where I got that. __________________ My guns include S&W and Colt revolvers, Colt and Ruger pistols, Remington 870 shotgun, Henry and Marlin .22LR rifles, Hi-Point 9mm carbine and Lancaster Arms AK. I reload handgun rounds with a Lee hand press, over 18K rounds since Nov. 2009 with nary a squib nor kaboom.