View Single Post
Old January 10, 2013, 01:33 AM   #2
wyop
Senior Member
 
Join Date: July 15, 2012
Location: Wonderful, Windy Wyoming
Posts: 133
Well, you'll likely find that unless you use a center drill, using a twist drill will wander off your mark in a hurry.

You'll need to slow the drill press way down to use a reamer, and you'll need to flood it with cutting oil or other lube.

Doing these kinds of jobs on floppy machines usually begets poor results.
wyop is offline  
 
Page generated in 0.03930 seconds with 7 queries