View Single Post
Old January 10, 2013, 12:01 AM   #24
Senior Member
Join Date: April 12, 2010
Location: Lake Martin, AL
Posts: 2,227
Like other have mentioned, you should hit against a thick piece of wood and against the grain (not with the grain). I keep a thick stud in a large vice on my reloading bench.

It does look as if it was hit with the wrong end of the tool. I can believe one will break, otherwise not the way the one in the picture broke. Heck, that one looks coceivable like the round could of almost gone off.
lamarw is offline  
Page generated in 0.03713 seconds with 7 queries