View Single Post
Old January 9, 2013, 10:07 PM   #6
William T. Watts
Senior Member
 
Join Date: January 20, 2010
Location: Central Arkansas
Posts: 725
I see no point deburring new straight wall pistol cases, the mouth of the case is belled,as a last step the case and bullet is taper crimped.. However, I do uniform primer pockets, deburr flash holes, check case length.. New rifle cases is another matter, they will have the expander partially run thru the neck, primer pockets uniformed, flash holes deburred, OAL checked, and checked in a cartridge case gage. William

Last edited by William T. Watts; January 9, 2013 at 10:15 PM.
William T. Watts is offline  
 
Page generated in 0.04286 seconds with 7 queries