View Single Post
Old January 9, 2013, 03:39 PM   #3
Ifishsum
Senior Member
 
Join Date: September 15, 2005
Location: Oregon
Posts: 710
Before you buy new dies, make sure that you're completely resizing the case - if they worked for the first three loadings then your shoulders have probably moved a little too far forward. Try screwing your die further down in the press about a turn, and with a case in the die make sure that the shellholder touches the bottom of the die at the top of its stroke. It could be touching the die when its empty, but there is a certain amount of springback in the press that can prevent the case from sizing completely. Easy to check anyway.
Ifishsum is offline  
 
Page generated in 0.04878 seconds with 7 queries