View Single Post
Old January 9, 2013, 01:17 PM   #1
Andyspiros
Member
 
Join Date: December 12, 2012
Posts: 37
ROA grip problems

Hey guys... Just picked up some ivory style grips for my stainless roa, only problem is that the dowel pin on the sides of the grip frame don't line up with the holes on the grips. Anybody ever run into this before? I was thinking about just "carving" out new holes on the inside of the grips. Any other ideas?
Andyspiros is offline  
 
Page generated in 0.04194 seconds with 7 queries