View Single Post
Old January 8, 2013, 12:32 AM   #4
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 17,048
If the gun shoots fine and the brass is undanaged, leave it alone.

We made polishing sticks out of 01 round stock. After filing one end flat (held against a machinust square), We brazed a brass dome on it. We then sawed a one inch slot down the center. Voila, polishing stick. We turned our barrels on the lathe and inserted the stick with a 1" emery strip wrapped around it.
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is offline  
 
Page generated in 0.04109 seconds with 7 queries