View Single Post
Old January 7, 2013, 05:15 AM   #5
Rainbow Demon
Senior Member
 
Join Date: September 27, 2012
Posts: 397
A stopgap method till you obtain the proper size ball is to set the balls on a steel plate and give then a light rap with a light hammer. This turns the round ball into an oblate sphere, increasing diameter at its equator.
The rap with the hammer should leave a small flat on top and bottom of the ball so you just have to be sure to seat the ball with the flat up and well centered.
Rainbow Demon is offline  
 
Page generated in 0.03951 seconds with 7 queries