View Single Post
Old January 6, 2013, 10:24 PM   #7
Idashot1k
Junior Member
 
Join Date: January 6, 2013
Location: East Idaho
Posts: 13
The first load was with a 240gr HP berry's bullet and 16.5gr of 2400.

The second was with 300gr sierra SP with 18gr of H110

Both loads were with the same FC and PMC brass.

These are the loads that didnt stick. Anything hotter than this and they started sticking.

The brass are tumbled and the cylinders cleaned after every session(to my specs, but im still new to this). I measured them and they're all the trim-to length. Sized brass slips right in.
Idashot1k is offline  
 
Page generated in 0.03887 seconds with 7 queries