View Single Post
Old January 6, 2013, 10:13 AM   #2
Roy Allain
Member
 
Join Date: October 28, 2007
Location: Harvey, La
Posts: 25
Redding Type S Bushing Dies

Is this a custom rifle? Or a factory rifle?

I a factory rifle, you need do nothing. Any cartridge will fit.

If a custom, do the following:

If you can, load one (1) empty unprimed brass with the bullet of your choice. Then measure the neck OD with a micrometer. The demension is what your basic cartridge will be when you insert it into the chamber.

Again, if a custom chamber, what is the chamber neck demension? Subtract .003 from that measurement. That is what your loaded round MUST measure to chamber properly and also release after firing.

There is much more, but we'll take one step at a time.

Roy
Roy Allain is offline  
 
Page generated in 0.04978 seconds with 7 queries