View Single Post
Old January 6, 2013, 09:11 AM   #7
oneoldsap
Senior Member
 
Join Date: September 16, 2009
Location: I live in the foot of the Green Mountains of Vermont
Posts: 1,585
I would install a sight ramp with screws . Gluing it won't be dependable , and brazing or silver soldering require right around 800-1200 Deg. F heat to melt things together . The heat will ruin the finish on your barrel , and it's not as simple as you might think . A pin has to be installed in the sight , which goes in an alignment hole in the barrel , aligning and holding sight in place while soldering or brazing . Two holes , drilled and tapped should cost $50.00 or less , screw it on , done !
oneoldsap is offline  
 
Page generated in 0.04015 seconds with 7 queries