View Single Post
Old January 5, 2013, 11:51 PM   #2
Creeper
Senior Member
 
Join Date: September 9, 2008
Location: Woooooshington
Posts: 1,797
Good question... considering I've never used it for anything but bedding.

I don't think it will take much of a hit, but if you're careful, it should tolerate temperature and vibration well enough. Make sure your surfaces are course sanded or blasted bare metal (for a good "tooth") and completely clean.

Perhaps a better choice would be a metalized epoxy, JB weld, that sort of thing.

C
__________________
Shoulder Drive Nicholson Club
Creeper is offline  
 
Page generated in 0.04062 seconds with 7 queries