View Single Post
Old January 5, 2013, 06:24 PM   #12
Don P
Senior Member
 
Join Date: December 17, 2005
Location: Florida
Posts: 4,812
Quote:
You might save someone a bit of grief if you specified whether you sanded on the inside of the round plastic "box" or on the outside of the aluminum turret, or both.

It may seem obvious to you but leaving any detail of your instruction out is a potential stumbling block for those who follow you.
Normally I would roll right by this response. Anyone stupid enough the Dremel the turret to make it fit in the red round box has ABSOLUTELY NO BUSINESS RELOADING THERE OWN AMMO.....PERIOD.......
TELLS ME THAT PERSON HAS ZERO COMMON SENSE.....
..
__________________
NRA Life Member, NRA Range Safety Officer, IDPA Safety Officer, USPSA NROI Range Officer
As you are, I once was, As I am, You will be.
Don P is offline  
 
Page generated in 0.04386 seconds with 7 queries