View Single Post
Old January 3, 2013, 12:17 AM   #5
MikeSD
Junior Member
 
Join Date: January 2, 2013
Posts: 5
I used a torque driver to tighten the screws. I set the driver at a little under 20 in-lbs of torque, on the ring halves. I think I'm ok there. But good to know I'm worrying about nothing on the ring spacing.



When I get the new base, I'll move the scope back about 1". I'll just have enough room to avoid the ejection port.
MikeSD is offline  
 
Page generated in 0.05089 seconds with 7 queries