View Single Post
Old January 2, 2013, 11:29 PM   #4
srfisher3
Member
 
Join Date: November 3, 2012
Posts: 17
I would be most concerned (or perhaps the correct word is careful) about how tightly you torgue the rings to the scope if you're moving them. The tension you apply with the wrench will definitely apply more pressure on the tube than the recoil of the .22W. Its a quality scope for sure and totally made for the recoil of a .22. Be cautious when tightening the screws and you'll be just fine.
srfisher3 is offline  
 
Page generated in 0.04362 seconds with 7 queries