View Single Post
Old January 2, 2013, 07:07 PM   #10
Lost Sheep
Senior Member
 
Join Date: January 24, 2009
Location: Anchorage Alaska
Posts: 2,996
Where did you sand?

Quote:
Originally Posted by Don P
Same problem here, I cured it with the good old Dremel using the sanding bands on a sanding drum,
Got all 6 turrets to fit nice.
You might save someone a bit of grief if you specified whether you sanded on the inside of the round plastic "box" or on the outside of the aluminum turret, or both.

It may seem obvious to you but leaving any detail of your instruction out is a potential stumbling block for those who follow you.

Thanks for your post. Thankfully, my die boxes it just fine.

Lost Sheep
Lost Sheep is offline  
 
Page generated in 0.05516 seconds with 7 queries