View Single Post
Old January 1, 2013, 08:40 PM   #11
deerslayer303
Senior Member
 
Join Date: January 10, 2011
Location: Leesville SC
Posts: 1,367
Thanks for all the tips guys its much appreciated. This is the first batch of bullets with a brand new mold. I cleaned it with alcohol and smoked it with an unscented candle. My pot had WW lead in it so I had to melt that drain it and then throw in the corn cob ingots I made a while back that are melted down roof flashing from the scrap yard. I think you guys are on to something though its been about 8 months since my pot was clean. The next batch I will flux the crap out of before casting. But this batch is destined for about 1400 FPS
__________________
"I prefer dangerous freedom over peaceful slavery."
- Thomas Jefferson
deerslayer303 is offline  
 
Page generated in 0.04062 seconds with 7 queries