View Single Post
Old January 1, 2013, 08:35 AM   #3
Garycw
Senior Member
 
Join Date: May 27, 2011
Location: Ohio-Kentucky - florida
Posts: 1,171
Is it even possible?

Is it even possible for the short piston to move up into the gas tube some if the release lever is moved all the way up to release position? I will put upside down on gun vise & get out the hammer. If it does come out without damaging it, I suppose I'll try filing/ grinding some off the end of the gas tube closest to the bolt. ?
Garycw is offline  
 
Page generated in 0.05571 seconds with 7 queries