View Single Post
Old January 1, 2013, 12:00 AM   #57
reynolds357
Senior Member
 
Join Date: December 10, 2012
Posts: 2,432
Ideally what you want is a full length bushing die manufactured to your chamber, not SAAMI spec. My last 1000 yd rifle came with a set of dies custom made for that chamber. In essence, it is a full length sizing die that is doing nothing but neck sizing. When using off the shelf dies, I have seen very little (if any) accuracy gained by neck sizing, and I have seen a lot of reliability loss due to neck sizing.
reynolds357 is offline  
 
Page generated in 0.04332 seconds with 7 queries