Thread: Spare parts
View Single Post
Old December 31, 2012, 03:12 PM   #3
Sabre9mm
Senior Member
 
Join Date: July 31, 2012
Location: Texas
Posts: 262
Aside from just some manufacturing fault or freak accident, any idea what the duty cycle on any of these are?

I have not owned it long, < 1k rounds since it was new, cleaned meticulously after every range visit.

I see things that were once black are now shiny, but cannot see any visible signs of anything other than cosmetic wear on anything.

essentially is there a point where something should be replaced because of use *Just to be sure* like changing the oil, or keep it clean then run it till it breaks?
Sabre9mm is offline  
 
Page generated in 0.04094 seconds with 7 queries