View Single Post
Old December 30, 2012, 11:48 PM   #10
big al hunter
Senior Member
 
Join Date: March 12, 2011
Location: Washington state
Posts: 922
The problem with jointed cleaning rods is that the edge of the joint wears on the bore. Even a one piece aluminium rod is bad for the bore. So use the bore snake for cleaning after shooting sessions. Get a one piece stainless rod and a bore guide. Always clean from the chamber end. Remove the bolt and don't drag dirty patches back through the bore.
__________________
You can't fix stupid....however ignorance can be cured through education!
big al hunter is offline  
 
Page generated in 0.04473 seconds with 7 queries