View Single Post
Old December 30, 2012, 06:17 PM   #5
m&p45acp10+1
Senior Member
 
Join Date: May 3, 2009
Location: Central Texas
Posts: 3,307
Chris mine it sheared off completely. It was not the perfect around cut though. It was a jagged, and very uneven. It did blow some powder back at me. The magazine follower, floor plate, and spring all shot out. I found the floor plate at my feet.

I inspected the brass. Paper clip test, and measured for length. All were in spec. The smith sectioned a couple of pieces. Noting wrong. I am going to chalk this up to a bad round. I fired some of my reloads today. All went bang. Looks like the gas plug in my rifle is stuck though. I will have to look around to find the wrench for the gas plug nut. If you guys could be kind enough to point me to somewhere with a link that has one that is not on ebay. (I do not do pay pal.)
__________________
No matter how many times you do it and nothing happens it only takes something going wrong one time to kill you.
m&p45acp10+1 is offline  
 
Page generated in 0.03983 seconds with 7 queries