Thread: 80%
View Single Post
Old December 29, 2012, 10:19 PM   #3
saands
Senior Member
 
Join Date: November 14, 1999
Posts: 1,563
I know that they are possible to do with a drill press, but they are dead simple with even the cheapest of mills and a jig. I have read great things about Tactical Machining in Florida ...

One thing to keep in mind is that you will want to finish the lower with something ... hard anodize is the norm and that usually runs $75-$100 per batch ... so it really pays to do a bunch of them with friends. Another thing is that you will need a couple of long end mills ... again, good to split with friends.


Saands
saands is offline  
 
Page generated in 0.04551 seconds with 7 queries