Thread: Warped brass
View Single Post
Old December 29, 2012, 08:58 PM   #5
Senior Member
Join Date: October 18, 2006
Posts: 6,117
To keep a seater/crimp die from crimping, use a nickel as a spacer. Put the ram in the up position, screw the die down to the nickel. That works with the Lee dies I've used.

"Gorsh" said Goofy as secondary explosions racked the beaten zone, "Did I do that?"
Jimro is offline  
Page generated in 0.04535 seconds with 7 queries