Thread: Warped brass
View Single Post
Old December 29, 2012, 08:50 PM   #2
Senior Member
Join Date: October 18, 2006
Posts: 6,117
Your seater die is doing that randomly?

Either you didn't trim the brass uniformly and the seater die is impacting the extra brass...

Or, your seater die is also a seater/crimp die and you are randomly bottoming out on an improperly adjusted die.

My money is on the second option.

"Gorsh" said Goofy as secondary explosions racked the beaten zone, "Did I do that?"
Jimro is offline  
Page generated in 0.04690 seconds with 7 queries