View Single Post
Old December 28, 2012, 03:37 AM   #1
A pause for the COZ
Senior Member
 
Join Date: October 11, 2012
Location: Braham, Minnesota
Posts: 402
How many ways to lube some lead.

Whew, there sure are a lot of ways to lube up some projectiles.

1st way I leaned was tumble lubing with Alox and shooting as cast.
I still do this a little for a few calibers I dont have sizing dies for.

The next way I learned was pan lubing. I still do this quite a bit for rifle calibers. Esp ones I do not have a good top punch for.

My favorite way is to melt some NRA formula around some bullets in a small pan. I use my $1.50 Goodwill toaster oven for this.



I cut them out with a Lyman Kake cutter. I nab these when ever avalible on Ebay.



Gas check them and run them through a LEE push through sizer.



Continued.
A pause for the COZ is offline  
 
Page generated in 0.05161 seconds with 7 queries