View Single Post
Old December 26, 2012, 03:56 PM   #13
Senior Member
Join Date: August 1, 2010
Location: Tampa Bay
Posts: 3,682
Rock Solid mount, or what I used- a Weaver Side Mount as shown below.
You need the skill and equipment (drill press) for the d&t mounts.
I made my own bent bolt, not difficult if you have a welder..
Made pillars from steel rod, epoxy bedded the receiver into a Boyd's stock.
Timney trigger.
Cut (22") and re-crowned (11 degree target crown) with a PTG crowning tool.

Shoots sub moa with SMK handloads.

Good ideas, here:
tobnpr is offline  
Page generated in 0.07992 seconds with 7 queries