Thread: Is it true....
View Single Post
Old December 25, 2012, 07:22 PM   #20
dahermit
Senior Member
 
Join Date: October 28, 2006
Location: South Central Michigan...near Ohio, Indiana.
Posts: 4,267
Quote:
And on the MIM- Ruger is expanding the use of MIM parts across the board.
I drew the inference that the poster thought that Ruger revolvers were MIM. Despite the fact that Ruger may being going to all MIM internal parts, I doubt that the cylinder and frame will utilize MIM, but will stay with investment cast. Investment cast with mostly MIM parts still does not an "MIM revolver" make.
dahermit is offline  
 
Page generated in 0.04639 seconds with 7 queries