View Single Post
Old December 24, 2012, 07:38 PM   #6
BillM
Senior Member
 
Join Date: January 20, 2009
Location: Amity Oregon
Posts: 345
If you strike out with conventional methods--

drill a clean hole all the way through the pin.
Fill the hole with grease.
Drop in a piece of drill rod, pin stock, or a short chunk
chopped off of the butt of the drill you used for the
hole.

Whack the end of the drill bit chunk/whatever with a
hammer. Messy, but it should hydraulic the pin out.
BillM is offline  
 
Page generated in 0.04869 seconds with 7 queries