View Single Post
Old December 24, 2012, 10:58 AM   #12
wyop
Senior Member
 
Join Date: July 15, 2012
Location: Wonderful, Windy Wyoming
Posts: 133
The OP's picture is of a normal recent 700 bolt face.

Have you had a headspace gage in the chamber yet to see if it is a tight chamber? With a "go" gage in the chamber, you should be able to strip the guts out of the bolt, put the gage into a clean chamber and the bolt should just drop closed. If it doesn't, then you might have a short chamber and that's why after firing a few rounds dirtying up your chamber, your bolt starts exhibiting trouble closing.

Last edited by wyop; December 24, 2012 at 11:05 AM.
wyop is offline  
 
Page generated in 0.05303 seconds with 7 queries