View Single Post
Old December 23, 2012, 12:24 PM   #1
db creekside
Junior Member
 
Join Date: December 23, 2012
Posts: 8
Model 700 bolt issue

Here is an image of a typical .308 case from my Model 700. From what I've read I have an extractor problem. After about 5 - 6 rounds the bolt is really hard to close until I clean out the little brass shavings from the chamber face and the bolt face (bolt face image also attached). That's Remington brass and this has been a problem from the start.

The rifle has little more than 100 rds thru it but is over 12 years old... that's another problem... recently somewhat solved by finding a place to shoot!

Anyway, I'm hoping to learn from the experience others have had with this issue and what might be some possible solutions.

Thanks in advance!
Attached Images
File Type: jpg case- rim shaved.jpg (118.7 KB, 99 views)
File Type: jpg bolt face.jpg (97.2 KB, 109 views)
db creekside is offline  
 
Page generated in 0.04454 seconds with 8 queries