View Single Post
Old December 20, 2012, 11:58 AM   #21
Brass pitcher
Junior Member
 
Join Date: December 18, 2012
Posts: 13
Well .308 will not fit, .243 will not fit, 7.62x39 fits but it pushes forward farther than the bolt will catch it if I push it in manually

More and more im thinking I need to go ahead and either find a smith or order some cerosafe.

Any ideas on what I can expect to put out for a smith?

Ok, I have decided that, I want it to be right before I would sell it, but I dont want it in any caliber but a .308 or -06 so any ideas about how much it might cost to rechamber? I would neeever do it to an original but its already done so no reason not to.

Again thanks for putting up with my ignorance yall, and for the information.

Last edited by Brass pitcher; December 20, 2012 at 07:15 PM.
Brass pitcher is offline  
 
Page generated in 0.04030 seconds with 7 queries